Hi all,
I've had my 71' wagon for a few years but recently have started to get a little deeper into the project
spent a long time working to 3d print a new hinge cover when I was separated from the car
currently in the midst of replacing the rockers and cleaning up floor pans
recently picked up an L20B so I'm hoping to find some good info on the swap here
new member
new member
- Attachments
-
- 3 d printed vs original hinge cover
- hinge cover.png (680.29 KiB) Viewed 554 times
-
- this is right after I finished replacing the driver's side rocker
- PXL_20231008_191035256~2.jpg (637.13 KiB) Viewed 554 times