Trunk hinge hardware question?
- eastbaysolo_73
- Supporter
- Posts: 705
- Joined: 18 May 2014 09:28
- Location: Northern California
Trunk hinge hardware question?
Does anyone have a photo of how the hardware orientation for the hinges that hold up the rear deck lid. I just got some and there's this funky looking washer that came with it. Where does that washer go. My car isn't using the correct hardware currently so I don't know. A photo would be appreciated. Thanks in advance guys.
1970 2 door sr20det cookie cutter build
My build thread
http://www.the510realm.com/viewtopic.php?f=3&t=30772
Nor Cal Meng !
My build thread
http://www.the510realm.com/viewtopic.php?f=3&t=30772
Nor Cal Meng !
Re: Trunk hinge hardware question?
The pivot bolts are "shouldered" so they tighten up BEFORE they squeeze the hinges firm. Do you mean the "wavy washer"??
1973 510 2dr
1972 521 flat bed
1972 510 Wagon parts car
2009 Toyota Matrix S AWD
LOTS of 510 parts!
1972 521 flat bed
1972 510 Wagon parts car
2009 Toyota Matrix S AWD
LOTS of 510 parts!
- eastbaysolo_73
- Supporter
- Posts: 705
- Joined: 18 May 2014 09:28
- Location: Northern California
Re: Trunk hinge hardware question?
Yes the wavy washer thanks. Stu sent me some photos via messenger on how they mount. Thank you
1970 2 door sr20det cookie cutter build
My build thread
http://www.the510realm.com/viewtopic.php?f=3&t=30772
Nor Cal Meng !
My build thread
http://www.the510realm.com/viewtopic.php?f=3&t=30772
Nor Cal Meng !