The 510 Realm

picked this up a couple years ago and am redoing the wiring and adding some goodies. Going from a MSD 7 box to a 10plus. Adding a Racepak V300 data aquisition system with dash, NLR 1000AMS boost controller, fire supression system and have a second 2850 Pauter motor in the works with a Garrett GT4202R turbo, with mechanical meth injection.

have to get the pictures resized as I have nothing as small as the 750 max.....

turbo is a triple ceramic bearing Comp turbo that I bought to only find out it is too small for the power I am hoping to achieve (800-900 rwhp)

rear wing and parachute missing..

then hope to turn this:


and these:


into something more like this:

Oh THAT looks like fun.....

All that and a fram too???

datzenmike wrote:All that and a fram too???

Very Nice ! hows the Ghia holding up?

I have a couple of friends that I used to hang out with in BC that are still into the VW stuff. The turbo car to beat at the time was Darren's Tomato Bullet from CIP.
Darren Dilley car is pretty darn fast as well http://www.youtube.com/watch?v=f_32v8kiEcw . I guess he has a crazy notch as well. He has always had some fast VW as long as I have know him.

I could go on but this is your thread let us know how it runs this spring. !

One car I wish I had not sold up there was a 54 euro 3 fold rag.

I race against Darren in a few different classes. The Ghia is still sitting quiet in the garage. I haven't had the time to get to it. Also due to an injury at work I haven't been getting a steady pay cheque for some time so only pick away at small stuff. I have run the Bettle on a very light tune up and did a 10:30 142mph. The car as is should run low 9's (high 8"s if I am brave and have a big bank roll to replace parts). Right now I just would like to get it into the mid 9's with the changes I have started.

I take it this thing will not get good fuel economy on our Canyon drives........

anyone good at wiring.....

No blinkers to wire , ought a be a cinch!

I'm patiently waiting to drag my 69 Baja outta its storage and dig into it with my kids, funny I don't even know where to get parts these days

AVR in Abottsford or Cal Imports cip1.com you can order from them and go pick up the next day just off of 200 street North side of the freeway