I have an intake assembly consisting of 2 ea 44mm Mikuni carbs, Datsun Comp manifold, insulators, velocity stacks, center pull throttle linkage & a spare set of 4 chokes.
This setup was dyno tuned on my recently built Rebello engine.
I'm using the same setup on the rebuilt engine that I used on the engine I replaced that I had tuned by Dave Premo of Performance Tuning, an authorized Mikuni Distributor.
His contacts are: web site=www.tuning4performance.com email=dave@tuning4performance.com Phone=925-288-1794 Mobile=925-890-8074.
I prefer to sell the assembly complete for $2500. Send me your email for pics.
Dean
gzentas510@outlook.com
FS Intake Assembly
Re: FS Intake Assembly
The intake assembly manifold is for a KA24 12 Valve head. I have a couple spare of those heads that will work on a Z24 block too.