The 510 Realm

Track Junky wrote:This is not like you Indy! There's front wheel well gap showing

Scott.

indy you should go 195/50/15 or 165/55

I'm telling you its not I'm not asking you. ...Is this the part where you start acting like my dad?? If so, where have you been the last 30 something years?? We have a lot of catching up to do!! :? Read back through your posts, you opened it for discussion and now you don't like it, it didn't go yo...

They go low but not low enough for me, otherwise i would keep them. i wana go this low. And before anyone says it, yes i know he has D50 cut springs with camero shocks. http://farm6.static.flickr.com/5215/5470639172_456f3bb93f_o.jpg ....sounds like discussion to me.... :roll: I'm telling you its no...

Nismotrd the springs are 300lbs.

Sleepys-14, poweredbymax sells knuckles for lowered cars so you won't over steer and still be low.

And for everyone else gtfo, I'm just trying to sell coilovers, this is a for sale add not a discussion.


Thank you

They go low but not low enough for me, otherwise i would keep them.





i wana go this low. And before anyone says it, yes i know he has D50 cut springs with camero shocks.

SOLD!!!!!!!!!!!!!! NEW PRICE $550 New techno toy tuning rear coilovers with 300lbs springs with adjustable AGX shocks, for a Datsun 510. I bought them a few weeks ago and installed them, but never driven on since I haven't finished my engine swap yet, 0 miles on them. Price is $600 firm Located in S...

to disconnect i think you can just hit it on the side with a hammer and then just pull it off. i just read i thread about it on ratsun, it had a youtube video, illl try looking for it but doubt ill find it.

http://pirate4x4.com/tech/billavista/PDFs/Federal_Mogul_how_to_measure_driveshaft%20angles.pdf Don't forget you can re-shim the diff! I have found that I keep my drive shaft angularity within 2 degrees, on my 510, otherwise you will have fierce vibration and rumble. I think that is why Nissan actua...

Then you need to ask better questions. A 510 D/S snout will fit in a KA trans, but you'd know this if you bothered to search one of the many, many threads on shortening D/S to fit swapped 510s. Or, again, bothered to try it yourself first. I asked which height of the transmission is saver, if the p...

umm yeah its obviously to long, i was asking about fitting in the transmission.

Hello, almost done with ka swap but now not sure on trany crossmember and driveshaft. *1. crossmember I have a ka24de with stock transmission, using 510 motor mounts. trying to figure out how high the transmission should be. ive seen both ways done (pictures below). And noticing one is lower than th...

not a 2dr but still fender mirrors

dodgydan wrote:hay all. i have seen a 510 somewere on here that has yellow hi beam lights. i liked the look but not sure if its legal up here. does anyone know of a supplier? i have checked around and came up empty. seems to be a europe trend

You could just get 3000k hids

maybe a 350z forum would be better to ask, nicoclub?

RonM wrote:Not sure if you're aware of this, but if you are razing the tranny, you'll also need to open the shifter hole a bit to allow the shifter block and rubber seal to come above the top of the tranny tunnel.

Yeah i made the shifter hole bigger, thanks.